I am reposting from another board (ET), BUT we needed a First Post Here...
I had previously installed the the first 4 items below, however the Bose system did not like the new head unit and would consistenlty fade or sound bad. The ground was also problematic and would whistle in all gears if the volume was too low.
My solution was to rip out everything and completely rewire the car. Project was just recently completed and the sound is very nice.
Part List:
1.) Kenwood DDX 6019 Double Din Head Unit
2.) Kenwood KNA-G510 (Garmin Navigation)
3.) Kenwood KCA-IP500 (IPOD Interface)
4.) Kenwood BT-100 (Bluetooth Interface)
5.) Polk MOMO MMC5250 Component Door Speakers (2 Sets, as all doors have a separate Tweeter & Speaker)
6.) JL Audio 12" W3V2 Sub
7.) Custom Sealed Box built by Showtime Audio in Chicago
8.) Alpine MRP-M450 MONO 400W RMS Amplifier (Sub Amp)
9.) Alpine MRP-F450 4-Channel 100W RMS x 4 Amplifier (Door Amp)
10.) Custom Amplifier Board built by Showtime Audio in Chicago
11.) Monster 300 Series Amplifier Power Kit 500 Watts
12.) Monster 200 Series Power Distribution Block
13.) Monster 402 XLN Extreme 2 Channel Subwoofer RCA Cable (5 meters)
14.) Monster 404 XLN Extreme 4 Channel Door Speakers RCA Cable (5 meters)
15.) 100 Feet 16 Gauge Speaker Wire (door wire)
16.) 6 feet 12 Gauge Speaker Wire (Sub)
BEFORE:
NEW PARTS:
INSTALL:
RESULTS:
CUSTOM AMP BOARD & BOX - Built by SHOWTIME AUDIO
